Tuesday, March 24, 2015

Best Automatic Car Alarm

Even the best car alarm is useless if you forget to set it upon leaving your car, whence this circuit. The relay has a make and a break contact: the  former is necessary to delay the switching in of the  alarm after you have got out of your car, and the  latter serves to switch on the car alarm proper. Immediately on re-entering your car, you must press the hidden switch, Si. This causes silicon-controlled rectifier Thi to conduct so that the relay is energized. At the same time, the green LED lights to indicate that the alarm is switched off. 

 Best Automatic Car Alarm Circuit Diagram

Best Automatic Car Alarm-Circuit Daigram

As soon as the ignition is switched off, T, is off, T2  is on, and the buzzer sounds. At the same time,  monostable IC1 is triggered, which causes T3 to  conduct and the red LED to light. The silicon- controlled rectifier is then off, and D4 is reverse  biased, but the relay remains energized via its make  contact for a short time, preset by Pi As soon as this  time has lapsed, the relay returns to its quiescent  state, and the alarm is set via the break contact. The  delay time can be set to a maximum of about 1 minute.

No comments:

Post a Comment